Horizontal/Vertical Tool Rest

Features

• 3/8″ thick steel
• 16″ wide by 5″ deep
• Three spacers are supplied so that the rest can be moved closer to the edge or closer to the middle of the belt (1/8″, 3/8″, 1/2″)
• Bolts directly onto a 1.5″x1.5″ (supplied) tooling arm
• When used in the horizontal position on our Dominator grinder the bottom wheel shield can be attached to the edge of the tool rest to avoid parts flying off.
• Last picture shows the rest in the horizontal position, speed so that it’s about 1/8″ up from the bottom of the platen (belt grinder set up obviously not included with tool rest!)